CP-plus digital control unit also for air-conditioning Saphir Compact/Comfort RC

The digital control unit

can not only be used for our heater type Combi 4 or Combi 6 (gas/electro- or dieselversion), but is also compatible with our air-conditioning system Saphir Compact  and Comfort RC.

It must be notified, that the air-conditioning System Saphir Compact can only be operated with the digital control unit with serial-number 23091001 or higher. Otherwise the electronik must be changed in adition.

Mover XT – LED 3 of remote control flashes 4 times

If the remote control emits an acoustic signal four times after beeing switched on and the red warning triangle (LED 3) flashes four times at the same time, the cause therefor could lie on the batteries, the battery voltage or on the remote control itself.

We recommend the following procedure in order to narrow down the cause.

1. Check that rotary switch and slide switch are in neutral position.

2. Check batteries of remote control (voltage) and replace if necessary.

The battery voltage of the remote control must be greater than or equal to 3,6 V (3 x 1,5 V AAA batteries). If rechargeable batteries are being used, it must be noted that because of the lower voltage of the rechargeable battery (3 x 1,2 V) the remote control is operated right at the limit and the rechargeable batteries have to be replaced or charged at frequent intervals!

3. Check battery quality.

Please use only high quality, leak-proof batteries with steel casing. Low-cost  batteries with a simple aluminium casing are not leak-proof and may also cause problems in the remote control.

4. Check software version.

The error could also appear with software version 1. The software version (HW 1 or HW 2) can be identified on the label above the batteries.

Should the software version be HW 1 or the above mentioned actions do not show any success, please contact our service.